Horner-apg SmartStack I/O HE-THM100 Uživatelský manuál stáhnout pdf (Strana 3)

MAN0237-09 10 NOV 2006 PAGE 3

THM000/100

This Data Sheet is published individually & also as a part of the SmartStack Supplement (SUP0246-05).

Information is subject to change without notice. SmartStack is a trademark of Horner APG, LLC.

3 CONFIGURATION

Note: The status of the I/O can be monitored in Cscape Software.

Preliminary configuration procedures that apply to SmartStack™ Modules are contained in the hardware

manual of the controller you are using. Refer to the Additional References section in this data sheet for

a listing of hardware manuals.

Module Setup Tab

a) Sensor Type for each channel must match what is physically attached.

b) Temperature format may be set for various C° or F° ranges. (This does not

apply to millivolt

ranges.)

c) Filter Constant sets the level of digital filtering according to the chart below.

d) Reject Rates sets the frequency level for noise rejection at 50 or 60HZ.

I/O Map Tab

The I/O Map describes which I/O registers are assigned to a specific SmartStack™ Module and where the

module is located in the point map. The I/O Map is determined by the model number and location within

the SmartStack™. The I/O Map is not

edited by the user.

Digital Filtering. The illustration above demonstrates the effect of digital filtering (set with Filter

Constant) on module response to a temperature change.

750ms

1250ms500ms 1000ms250ms0

100

Scans

2 3 4 5 6 70

Filter

Constant

%Complete [ ]

1 2 3 4 5 6 7 8

Žádné komentáře

Horner-apg SmartStack I/O HE-THM100 Uživatelský manuál Strana 3